Long Reinforcing Channel. Used as floor reinforcing. 7-3/4" Long, 1-1/8" Wide. Used in the PMC24 and TM12 Houses to reinforce the floors.

Short Reinforcing Channel. 6 used per house to reinforce the ceiling on the PNC24 and TM12 Houses. This item was previously finished in green. It is now mill finish aluminum...

Front Rail For PMC24 and TM12 - 12 5/8". 6 per floor. 1 - #925060 Rail Replacement Kit per rail required.

1-1/2" x 74" Post. Bottom Section of SSP Post. Will also fit SSP, MSS12, TG12 and TM12 Posts. Also see #926216 Rope Cleat and #900012 Safety System Clamp Assembly...

1-1/4"x60-1/2" Post. Top Section of SSP Post. Will also fit MSS12, MSS8, TG12, TG8 and TM12 Posts. If replacing your top post section also see #926208 MSS12 Pulley...

1-1/4" x 76" Post. Center Section of SSP Post. Will also fit SSP, MSS12, TG12 and TM12 Posts. If replacing your center post section also see #900012 Safety System...

'B' Clamp (Tube Clamp) 1-1/2". Two required. Used as part of #900012 Safety System Pole Clamp Assembly and also the #900011 CP24 Pole Clamp Assembly.

TM-12 Tie Rod. 13" long. 6-32 threads. The image at left shows only one of the two threaded ends. 6 Required per house. Use #35288 6-32 Acorn Through nuts as fasteners.

1/4-20 X 3/4 Carriage Bolt. Used in #900012 Safety System Clamp Assembly (Used to connect lower and center sections of the pole) for SSP Poles. Also used in #900011 CP24...

1/4-20 x 1-1/4" Carriage Bolt. Used in #900002 TGS Ground Socket Hardware and #900003 MPS Ground Socket Hardware. MINIMUM ORDER - 2

1/4 x 2 Slotted Spring Pin. Used as top stop on TM12 and PMC24 Houses.      SSP Pole (For TM12 House): This pin is inserted into the hole that is located...

1/4-20 x 1-3/4" Hex Head Bolt. Used in TM12 Pulley. Also available in pre-assembled #932001 TM12 Complete Pulley Assembly.